Omron SYSDRIVE 3G3MV

!
!
!
!
!
!
!
!
!
!
2-11
2-2 Wiring
WARNING Wiring must be performed only after confirming that the power
supply has been turned OFF. Not doing so may result in electrical
shock.
WARNING Wiring must be performed by authorized personnel. Not doing so
may result in electrical shock or fire.
WARNING Be sure to confirm operation only after wiring the emergency stop
circuit. Not doing so may result in injury.
WARNING Alwaysconnectthegroundterminalstoagroundof100W orlessfor
the 200-VAC class, or 10 W or less for the 400-VAC class. Not
connecting to a proper ground may result in electrical shock.
Caution Install external breakers and take other safety measures against
short-circuiting in external wiring. Not doing so may result in fire.
Caution ConfirmthattheratedinputvoltageoftheInverteristhesameasthe
AC power supply voltage. An incorrect power supply may result in
fire, injury, or malfunction.
Caution If you use a Braking Resistor or a Braking Resistor Unit, connect
them as specified in the manual. Not doing so may result in fire.
Caution Be sure to wire correctly and securely. Not doing so may result in
injury or damage to the product.
Caution Besureto firmly tightenthe screws onthe terminalblock. Not doing
so may result in fire, injury, or damage to the product.
Caution Donotconnect an ACpower to the U,V, or Woutput. Doing somay
result in damage to the product or malfunction.
Design Chapter 2