Omron SYSDRIVE 3G3MV - Page 223

7-29
D Input Terminal Status (Register 002B Hex)
Bit No. Function
0 Multi-function input terminal 1 (S1) (1: ON)
1 Multi-function input terminal 2 (S2) (1: ON)
2 Multi-function input terminal 3 (S3) (1: ON)
3 Multi-function input terminal 4 (S1) (4: ON)
4 Multi-function input terminal 5 (S5) (1: ON)
5 Multi-function input terminal 6 (S6) (1: ON)
6 Multi-function input terminal 7 (S7) (1: ON)
7 to 15 Not used
D Inverter Status 1 (Register 002C Hex)
Bit No. Function
0 During RUN (1: During RUN)
1 Zero speed (1: Zero speed)
2 Frequency agree (1: Frequency agree)
3 Alarm (Nonfatal error) (1: Warning)
4 Frequency detection 1 (1: Output frequency  n095)
5 Frequency detection 2 (1: Output frequency  n095)
6 Inverter ready (1: Ready)
7 UV (1: UV)
8 Base block (1: Base block)
9 Frequency reference mode (1: Other than communications)
10 RUN command mode (1: Other than communications)
11 Overtorque detection (1: Overtorque detection)
12 Not used
13 Fault retry (1: Fault retry)
14 Fault (1: Fault)
15 Communications time-over: No normal communications for 2 s or
more
(1: Communications time-over detecting)
D Output Terminal Status (Register 002D Hex)
Bit No. Function
0 Multi-function contact output terminal MA (1: ON)
1 Multi-function photocoupler output terminal 1 (P1) (1: ON)
2 Multi-function photocoupler output terminal 2 (P2) (1: ON)
3 to 15 Not used
Communications Chapter 7