Omron SYSDRIVE 3G3MV - Page 242

7-48
Response Write
Determine whether or not to write the reception data in the response.
Note Always set this parameter to Yes for communications with 3G3MV.
Next Process
Determine which step is to be processed next or finish the operation after the step
finishes normally.
Note In this example, step 00 is set to Next and step 01 is set to END because the
sequence completes by executing steps 00 and 01.
Error Processing
Ifthestephasanerror,determinewhichstepistobeprocessednextorfinishtheopera-
tion.
Note In this example, the parameter will be set to Abort to interrupt the sequence if an
error occurs.
* Message Header
(h)
Terminator Check
code (c)
Length (l) Address (a) Data
®j
Input send *CRC-16
(65535)
(2Byte
BIN)
(0) (1Byte
BIN)
(R (3N+2), 1) <a> + [10] + [00] +
[01] + [00] + [02] +
<I> (R (3N + 3), 4) +
<c>
®j
Status *CRC-16
(65535)
(2Byte
BIN)
(R (3N+2), 1) <a> + [03] + [00] +
[2C] + [00] + [01] +
<c>
®j
Message
The label (name) of the sequence. Input an appropriate, easy-to-distinguish name.
Note Set the labelin the send messagebox in thetable shown underCreating a Step.
Header (h)
Terminator (t)
Set the header and terminator.
Note No header or terminator isused for communications withthe 3G3MV.Therefore,
set both to No.
Check Code (c)
Set the check code.
Communications Chapter 7