3-4
Power On
FREF (Frequency Reference)
Monitors and sets the frequency reference.
FOUT (Output Frequency)
Monitors the output frequency.
Note Thisindicatorwillbe litbyturningtheInverterONagain
if the Inverter is turned OFF while this indicator is lit.
IOUT (Output Current)
Monitors the output current.
Note ThisindicatorwillbelitbyturningtheInverterONagain
if the Inverter is turned OFF while this indicator is lit.
MNTR (Multi-function Monitor)
Monitors the values set in U-01 through U-18.
Note Depending on the inverter capacity, the
number of the Uxx is different.
F/R (Forward/Reverse Rotation)
Selects the direction of rotation.
LO/RE (Local/Remote)
Selects the operation of the Inverter through the Digital
Operator or according to the parameters.
PRGM (Parameter Setting)
Monitors or sets the values in n001 through n179.
The FREF indicator is lit again.
Note Thesettingunitofthefrequencyreferenceandoutputfrequencyisdeterminedby
the set value in n035. The default unit is Hz.
Preparing for Operation and Monitoring Chapter 3
To Next Page
Loading...
