Omron ZEN - Page 129

105
Stabilizing Input Operations Section 4-2
Press the OK Button to display the Input
Filter Settings Menu.
Use the Up and Down Buttons to select from
the menu the Unit for which the input filter is
to be set.
Press the OK Button to display the present
setting.
Press the OK Button again to change to a
flashing cursor and enable input filter
settings to be made.
Use the Up/Down Buttons to switch between
ON and OFF.
Press the OK Button to confirm the setting.
Press the OK Button again to complete the
setting.
Note
1.The filter timers outlined in the following table are set for each
input type when the input filter function is set.
2.The input filter settings are read when the ZEN starts operation.
PASSWORD
BACKLIGHT
INPUT FILTER
SYSTEM INF
▼
Select
Other/Input
filter.
INNER
EXP1
EXP2
EXP3
/
/
CPU Unit input
Expansion I/O Unit input
(Displayed only when Expansion
Units are connected.)
OFF
INPUT FILTER
INNER
OFF
INPUT FILTER
INNER
ON
/
Input specifications Input
filter not
used
Input
filter used
AC input 100 VAC 50 ms 70 ms
240 VAC 100 ms 120 ms
DC input 15 ms 50 ms
Z211-E1-03.book Page 105 Friday, November 21, 2008 10:38 AM