Omron ZEN - Correcting Ladder Programs; Changing Inputs; Changing Additional Bit Output Functions

71
Correcting Ladder Programs Section 3-5
3-5 Correcting Ladder Programs
3-5-1 Changing Inputs
Change contact Q0 to M1.
Press the OK Button to change the
highlighted cursor to a flashing cursor and
move the flashing cursor to the bit type
position.
Use the Up/Down Buttons to select M.
Press the Right Button to move the flashing
cursor to the bit address position. Use the
Up/Down Buttons to change the bit address
from 0 to 1.
Press the OK Button to complete the setting
change.
3-5-2 Changing Additional Bit Output Functions
Change the additional function for the input
for Q0 to S (Set).
Press the OK Button to change the
highlighted cursor to a flashing cursor.
Press the Left Button to move the flashing
cursor to the additional function position.
Press the Up Button twice to change the
additional function from [ to S.
Press the OK Button to complete the
change.
Move the
highlighted cursor
to the input to be
changed.
▼
▼
▼
Move the
highlighted cursor
to the output to be
changed.
▼
▼
▼
Z211-E1-03.book Page 71 Friday, November 21, 2008 10:38 AM