EasyManuals Logo

Omron ZEN User Manual

Omron ZEN
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
xix
Precautions
Installation Environment
1. Do not install the ZEN in the following locations.
Locations subject to radical changes in temperature
Location with high humidity subject to condensation
Locations subject to excessive dust or dirt
Locations subject to corrosive gas
Locations subject to direct sunlight
2. Do not install the ZEN in locations subject to shock or vibration. Extended use in
such location may cause damage from stress.
3. In environments subject to static electricity (e.g., close to pipes conveying
forming materials, powders, or fluid materials), separate the ZEN as far as
possible from the source of static electricity.
4. The ZEN is neither waterproof nor oil-proof. Do not use it in locations subject to
water or oil.
5. Use the ZEN within the allowable power supply voltage range. Be particularly
careful in locations with bad power supply conditions, e.g., large fluctuations in
the power supply voltage.
6. Do not install the ZEN in locations subject to excessive noise, which may cause
the ZEN to fail.
7. Take appropriate and sufficient countermeasures when installing systems in the
following locations:
Locations subject to strong electromagnetic fields
Locations subject to possible exposure to radioactivity
Power Supply
1. Always turn OFF the power supply to the ZEN (CPU Unit and Expansion I/O
Units) before attempting any of the following.
Assembling the ZEN
Attaching or removing Expansion I/O Units
Connecting or disconnecting any cables or wiring
Attaching or removing the Memory Cassette
Attaching or removing the Battery Unit
2. If the power supply is interrupted for 2 days or more (at 25°C
), the internal
capacitor will discharge and internal bit status and the contents of PV areas will
be lost or corrupted and dates and times will be reset. When restarting operation
after the power supply has been interrupted for an extended period of time, check
the system in advance to confirm that no errors will occur.
Handling
1. Connect connectors only after confirming that the direction or polarity is correct.
2. Failures could result if dust or dirt enters the ZEN. Always connect the connector
cover to the computer connector whenever it is not being used.
Precautions for Correct Use
Z211-E1-03.book Page xix Friday, November 21, 2008 10:38 AM

Table of Contents

Other manuals for Omron ZEN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron ZEN and is the answer not in the manual?

Omron ZEN Specifications

General IconGeneral
DisplayLCD
Mounting TypeDIN Rail
Operating Temperature-10 to 55°C
Power Supply Voltage100-240V AC
Output TypeRelay, Transistor
Number of Outputs4-8
Programming LanguageLadder Logic

Related product manuals