154
Application Examples Appendix E
Warming Molding Machines (Weekly Timer and Bit
Logic)
Application
The ZEN can be used to improve molding efficiency by warming up the molding machine
before the work shift starts. This allows molding work to begin immediately at the start of
the work shift.
When work shifts vary, pre-set weekly timers can be selected using a switch.
System Configuration
NC
10C1AR-A-V2
SW1 (I0) (Continuous operation)
SW2 (I1) (Pattern 1)
SW3 (I2) (Pattern 2)
SW4 (I3) (Pattern 3)
SW5 (I4) (Stop)
ZEN-
10C1AR-A-V2
Molding machine
heating circuit
Q0
Z211-E1-03.book Page 154 Friday, November 21, 2008 10:38 AM
To Next Page
Loading...
