OPTIMedical OPTI CCA-TS - Page 102

Operator’s Manual – OPTI CCA-TS 5-13
5 SAMPLE HANDLING AND PATIENT TESTING
The third tab displays calibration data from the gas
calibration preceding the measurement (Fig. 5-23).
19. Open the cover and remove the cassette and
press to go to the next sample.
To edit the patient data, press <Patient Data>.
NOTE: The printout will automatically start when
the rst results are displayed. This feature
may be turned off in setup (See Section
3.3.3.6).
Fig. 5-23 Calibration results