OPTIMedical OPTI CCA-TS - Page 130

7-12 Operator’s Manual – OPTI CCA-TS
7 DIAGNOSTICS AND TROUBLESHOOTING
The gas pressure is low.
• Replace the gas bottle (See Section 6.5.1).
The temperature is out of range.
• Wait for the analyzer to reach the correct
temperature.
• Cycle the power if the analyzer does not go to
<Ready> within a few minutes.
• If the analyzer does not become <Ready>
within a reasonable time, check the temperature
under <System - Diagnostics>.
Check that ambient temperature is within
operating specications on page 2-1.
The battery voltage is low.
• Operate the analyzer on AC power and/or
recharge the battery.