OPTIMedical OPTI CCA-TS - Page 80

Operator’s Manual – OPTI CCA-TS 4-9
4 CALIBRATION AND QUALITY CONTROL
3. Enter your Operator ID, or 4-digit PIN using the
alphanumeric keypad (Fig. 4-14).
To bypass this function, press
.
NOTE: IfOperatorIDisconguredas“required”
inSetup,youcannotgotothenextstepuntil
anumberisentered.
NOTE: IfSecureOp.IDsisactivatedunderSetup,
youwillbepromptedforyour4-digitPIN#
insteadofyourOp.ID.
NOTE: Bar-codedOperatorIDsmaybeentered
usingthebarcodescanner.
4. Select the desired level (Fig. 4-15) and press
.
5. Press if the lot number is correct
(Fig. 4-16).
NOTE: IfanewlotnumberofQCmaterialis
entered,makesuretherangeshavebeen
enteredintothesystempriortorunninga
sample.(SeeChapter3,Customization).
Ifthepasswordfunctionisenabled,youwill
beaskedforitbeforedeletingthedatabase
fortheoldlotnumber.
Fig. 4-15 Select QC Level
Fig. 4-14 Enter Operator ID
Fig. 4-16 Conrm Lot Number