Optos P200TE - 3.4.7.4 Battery replacement; 3.4.7.5 Cable management

Chapter 3 - How to...
Disinfection
CAUTION
Wear powder-free gloves at all times when cleaning the device including the scan head
and main mirror. If the gloves become contaminated they must be replaced immediately.
Always follow the cleaning and disinfecting agents’ manufacturer’s instructions and
precautions; for storage, method of application, protective gloves, shelf life and disposal
to help assure effective and safe use of the product.
Be careful NOT to damage the scan head covers when cleaning.
Do NOT use lint cloths, tissues, or other materials that may create dust, on or near the
scan head. Always allow cleaned areas to air-dry.
External surfaces must be cleaned of all visible contamination when they become dirty or soiled with bodily
fluids. Follow your internal clinic or hospital decontamination procedures.
Cleaning of the external surfaces of the device should be carried out on a regular basis, see General cleaning on
page56.
3.4.7.4 Battery replacement
CAUTION
Do NOT remove the scan head covers. Only Optos trained technical personnel are
permitted to service the device.
A 3V Lithium coin battery is embedded in the hardware for the device and does NOT require to be changed by
users. If there is a problem, please contact your Optos representative, see Contact us on page71.
3.4.7.5 Cable management
WARNING
DoNOT plug the scan head into a power block or powered table. The scan head must be
plugged directly into a wall socket.
To prevent electric shock:
l Only use cables supplied by Optos.
l
Cables should NOT be extended or altered.
l Mains supply must be earthed.
l The device may only be serviced by Optos trained personnel.
l Care must be taken never to touch exposed parts of the device while in physical
contact with a patient.
If the mains cable is damaged do not use the system and contact your Optos
representative, see Contact us on page71.
CAUTION
Ordinary equipment (IP2X), without protection against ingress of water.
You must regularly inspect the equipment. If there is any damage please contact your
Optos representative, see Contact us on page71.
Ensure the mains socket is easily accessible.
Part Number: G108707/8GME Page 59 of 75
Copyright 2018, Optos plc. All rights reserved. English