93
Servicing the FEM
The server module supports the installation of one FEM. To see a list of supported
FEMs for this server module, refer to the Netra SPARC T4-1B Server Module Product
Notes.
Related Information
■ “Detecting and Managing Faults” on page 5
■ “Preparing for Service” on page 51
▼ Remove a FEM
FEMs are available in single and double widths. Figures in this procedure depict a
single-width FEM, but the procedure applies to both types of FEMs.
1. Prepare for service.
See “Preparing for Service” on page 51.
2. Lift the lever to eject the FEM (panel 1).
Description Links
Replace a FEM. “Remove a FEM” on page 93
“Install a FEM” on page 94
Install a FEM. “Install a FEM” on page 94
To Next Page
Loading...
