Oracle Netra SPARC T4-1B - Service-Related Oracle ILOM Commands

22 Netra SPARC T4-1B Server Module Service Manual • June 2012
■ “Check for Faults (show faulty Command)” on page 18
■ “Check for Faults (fmadm faulty Command)” on page 20
■ “Service-Related Oracle ILOM Commands” on page 22
Service-Related Oracle ILOM Commands
These are the Oracle ILOM shell commands most frequently used when performing
service-related tasks.
Oracle ILOM Command Description
help [command] Displays a list of all available commands with syntax
and descriptions. Specifying a command name as an
option displays help for that command.
set /HOST send_break_action=break Takes the host server module from the OS to either
kmdb or OBP (equivalent to a Stop-A), depending on
the mode Oracle Solaris software was booted.
set /SYS/component clear_fault_action=true Manually clears host-detected faults. The component is
the unique ID of the device with a fault to be cleared.
start /HOST/console Connects to the host.
show /HOST/console/history Displays the contents of the host’s console buffer.
set /HOST/bootmode property=value Controls the host server module OBP firmware
method of booting. property is state, config,or
script
stop /SYS
start /SYS
Powers off the host server module and then powers on
the host server module.
stop /SYS Powers off the host server module.
start /SYS Powers on the host server module.
reset /SYS Generates a hardware reset on the host server module.
reset /SP Reboots the SP.
set /SYS keyswitch_state=value Sets the virtual keyswitch. value is normal, standby,
diag,or locked.
set /SYS/LOCATE value=value Turns the Locator LED on the server module on or off.
value is Fast_blink or Off.
show faulty Displays current server module faults. See “Check for
Faults (show faulty Command)” on page 18.
show /SYS keyswitch_state Displays the status of the virtual keyswitch.