Detecting and Managing Faults 33
Related Information
■ “POST Overview” on page 29
■ “Configure POST” on page 33
■ “Run POST With Maximum Testing” on page 35
■ “Interpret POST Fault Messages” on page 37
■ “Clear POST-Detected Faults” on page 37
■ “POST Output Reference” on page 39
▼ Configure POST
1. Log in to Oracle ILOM.
See “Access the SP (Oracle ILOM)” on page 15.
2. Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
The following example sets the virtual keyswitch to normal, which will configure
POST to run according to other parameter values.
For possible values for the keyswitch_state parameter, see “Oracle ILOM
Properties That Affect POST Behavior” on page 30.
/HOST/diag trigger hw-change error-reset none
/HOST/diag verbosity normal
Description of POST
execution
This is the default POST
configuration. This
configuration tests the server
module thoroughly and
suppresses some of the
detailed POST output.
POST does not run,
resulting in quick
initialization. This
configuration is not
suggested.
POST runs the full
spectrum of tests with
the maximum output
displayed.
* The keyswitch_state parameter, when set to diag, overrides all the other POST variables.
-> set /SYS keyswitch_state=normal
Set ‘keyswitch_state' to ‘Normal'
Oracle ILOM Parameter
Normal Diagnostic Mode
(Default Settings) No POST Execution
Service Mode Using the
Keyswitch_state
To Next Page
Loading...
Need help?
General
