Oracle Netra SPARC T4-1B User Manual

20 Netra SPARC T4-1B Server Module Service Manual • June 2012
Related Information
■ “Diagnostics Process” on page 7
■ “Access the SP (Oracle ILOM)” on page 15
■ “Display FRU Information (show Command)” on page 17
■ “Check for Faults (fmadm faulty Command)” on page 20
■ “Clear Faults (clear_fault_action Property)” on page 21
■ “Service-Related Oracle ILOM Commands” on page 22
▼ Check for Faults (fmadm faulty Command)
The following is an example of the fmadm faulty command, which is an alternative
to the show faulty command.
You must run the Oracle Solaris fmadm faulty command from within the Oracle
ILOM faultmgmt shell.
Note – The characters SPT at the beginning of a message ID indicate that Oracle
ILOM detected the fault.
1. At the Oracle ILOM prompt, access the Oracle ILOM faultmgmt shell.
2. At the faultmgmtsp> prompt, type the fmadm faulty command.
/SP/faultmgmt/0/ | fru_serial_number | 465769T+**********
faults/0 | |
/SP/faultmgmt/0/ | fru_part_number | 7015272
faults/0 | |
->
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
------------------- ------------------------------------ ------------ -------
Time UUID msgid Severity
------------------- ------------------------------------ ------------ -------
2011-08-11/14:54:23 ********-****-****-****-******* SPT-8000-LC Critical
...

Oracle Netra SPARC T4-1B Specifications

General

Brand	Oracle
Model	Netra SPARC T4-1B
Category	Server
Language	English