54 Netra SPARC T4-1B Server Module Service Manual • June 2012
Tools Needed for Service
The following tools are required for service procedures:
■ Antistatic wrist strap
■ Antistatic mat
■ Stylus or pencil (to operate the power button)
■ UCP-3 dongle (UCP-4 dongle can be used, but see instructions in the Server
Module Installation Guide)
■ Blade filler panel
Related Information
■ “Safety Information” on page 51
■ “Handling Precautions” on page 53
■ “Find the Modular System Chassis Serial Number” on page 54
▼ Find the Modular System Chassis
Serial Number
To obtain support for your server module, you need the serial number of the Sun
Netra 6000 modular system in which the server module is located, not the serial
number of the server module. The serial number of the modular system is provided
on a label on the upper left edge of the front bezel.
Use the following procedure to obtain the serial number remotely.
1. Log in to the CMM of the modular system.
See the documentation for the Sun Netra 6000 modular system.
2. Type.
3. In the output, locate the value for product_serial_number.
That number is the serial number of the modular system.
-> show /CH
To Next Page
Loading...
Need help?
General
