Detecting and Managing Faults 17
■ clear_fault_action property of the set command – Manually clears
PSH-detected faults.
See “Clear Faults (clear_fault_action Property)” on page 21.
Related Information
■ Oracle ILOM 3.0 documentation
■ “Display FRU Information (show Command)” on page 17
■ “Check for Faults (show faulty Command)” on page 18
■ “Check for Faults (fmadm faulty Command)” on page 20
■ “Clear Faults (clear_fault_action Property)” on page 21
■ “Service-Related Oracle ILOM Commands” on page 22
■ “Oracle ILOM Properties That Affect POST Behavior” on page 30
▼ Display FRU Information (show Command)
Use the Oracle ILOM show command to display information about individual FRUs.
● At the Oracle ILOM prompt, type the show command.
In the following example, the show command displays information about a
memory module.
-> show /SYS/MB/CMP0/BOB0/CH0/D0
/SYS/MB/CMP0/BOB0/CH0/D0
Targets:
T_AMB
SERVICE
Properties:
Type = DIMM
ipmi_name = P0/B0/C0/D0
component_state = Enabled
fru_name = 8192MB DDR3 SDRAM
fru_description = DDR3 DIMM 8192 Mbytes
fru_manufacturer = Samsung
fru_version = 00
fru_part_number = ****************
fru_serial_number = ******************
fault_state = OK
clear_fault_action = (none)
To Next Page
Loading...
Need help?
General
