16 Netra SPARC T4-1B Server Module Service Manual • June 2012
3. Open an SSH session to log into Oracle ILOM on the CMM.
The default Oracle ILOM login account is root with a default password of
changeme. The password might be different in your environment.
The Oracle ILOM prompt (->) indicates that you are accessing the Oracle ILOM
CLI.
4. Navigate to the server module.
Replace n with an integer that identifies the target server module (the slot in
which the server module is installed).
5. Start the server module SP Oracle ILOM CLI.
6. Perform Oracle ILOM commands that provide the diagnostic information you
need.
These commands are commonly used for fault management:
■ show command – Displays information about individual FRUs.
See “Display FRU Information (show Command)” on page 17.
■ show faulty command – Displays environmental, POST-detected, and
PSH-detected faults.
See “Check for Faults (show faulty Command)” on page 18.
Note – You can use fmadm faulty in the Oracle ILOM faultmgmt shell as an
alternative to show faulty.
ssh root@CMM_IP_Address
Password:
Waiting for daemons to initialize...
Daemons ready
Oracle (R) Integrated Lights Out Manager
Version 3.0
Copyright (c) 2011, Oracle and/or its affiliates, Inc. All rights reserved.
Warning: password is set to factory default.
->
-> cd /CH/BLn/SP/cli
-> start
Are you sure you want to start /CH/BL0/SP/cli? y
start: Connecting to /CH/BL0/SP/cli using Single Sign On
To Next Page
Loading...
Need help?
General
