Oracle Netra SPARC T4-1B User Manual

97
Servicing the SP Card
The server module has an SP card with firmware that provides Oracle ILOM.
■ “Remove the SP Card” on page 97
■ “Install the SP Card” on page 98
Related Information
■ “Detecting and Managing Faults” on page 5
■ “Preparing for Service” on page 51
▼ Remove the SP Card
1. If possible, save the configuration information for the SP.
Refer to the related procedures using Oracle ILOM in the SPARC and Netra SPARC
T4 Series Servers Administration Guide.
2. Prepare for service.
See “Preparing for Service” on page 51.
3. If a REM is installed in the server module, remove the REM.
See “Remove a REM” on page 89.
4. Push down on the tab to eject the SP card (panel 1).

Oracle Netra SPARC T4-1B Specifications

General

Brand	Oracle
Model	Netra SPARC T4-1B
Category	Server
Language	English