42 Netra SPARC T4-1B Server Module Service Manual • June 2012
■ Memory
■ I/O subsystem
The PSH console message provides the following information about each detected
fault:
■ Type
■ Severity
■ Description
■ Automated response
■ Impact
■ Suggested action for a system administrator
If PSH detects a faulty component, use the fmadm faulty command to display
information about the fault. Alternatively, you can use the Oracle ILOM command
show faulty for the same purpose.
Related Information
■ “Check for Faults (show faulty Command)” on page 18
■ “Check for PSH-Detected Faults” on page 42
■ “Clear PSH-Detected Faults” on page 44
▼ Check for PSH-Detected Faults
The fmadm faulty command displays the list of faults detected by PSH. You can run
this command either from the host or through the Oracle ILOM fmadm shell.
As an alternative, you can display fault information by running the Oracle ILOM
command show.
To Next Page
Loading...
