Detecting and Managing Faults 21
3. Type the exit command when you are finished using the Oracle ILOM
faultmgt shell.
Related Information
■ “Diagnostics Process” on page 7
■ “Access the SP (Oracle ILOM)” on page 15
■ “Display FRU Information (show Command)” on page 17
■ “Check for Faults (show faulty Command)” on page 18
■ “Clear Faults (clear_fault_action Property)” on page 21
■ “Service-Related Oracle ILOM Commands” on page 22
▼ Clear Faults (clear_fault_action Property)
Use the clear_fault_action property with the set command to manually clear
PSH-detected faults for a FRU.
If Oracle ILOM detects a FRU replacement, it will automatically clear the fault. For
PSH-diagnosed faults, if the replacement of the FRU is detected by the SP or the fault
is manually cleared on the host, the fault will also be cleared from Oracle ILOM. In
such cases, you typically do not have to clear the fault manually.
Note – This procedure clears the fault from the SP but not from the host. If the fault
persists in the host, clear it manually as described in “Clear PSH-Detected Faults” on
page 44.
● At the Oracle ILOM prompt, use the set command with the
clear_fault_action=True property.
For example:
Related Information
■ “Diagnostics Process” on page 7
■ “Access the SP (Oracle ILOM)” on page 15
■ “Display FRU Information (show Command)” on page 17
faultmgmtsp> exit
-> set /SYS/MB/CMP0/BOB0/CH0/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CMP0/BOB0/CH0/D0 (y/n)? y
Set ’clear_fault_action’ to ’true’
To Next Page
Loading...
Need help?
General
