Detecting and Managing Faults 31
locked The host can power on and run POST, but no flash
updates can be made.
/HOST/diag mode off POST does not run.
normal Runs POST according to diag level value.
service Runs POST with preset values for diag level and
diag verbosity.
/HOST/diag level max If diag mode = normal, runs all the minimum tests
plus extensive processor and memory tests.
min If diag mode = normal, runs the minimum set of
tests.
/HOST/diag trigger none Does not run POST on reset.
hw-change (Default) Runs POST following an AC power cycle
and when the top cover is removed.
power-on-reset Runs POST only for the first power on.
error-reset (Default) Runs POST if fatal errors are detected.
all-resets Runs POST after any reset.
/HOST/diag verbosity normal POST output displays all test and informational
messages.
min POST output displays functional tests with a banner
and pinwheel.
max POST displays all test and informational messages,
and some debugging messages.
debug POST displays extensive debugging output on the
system console, including the devices being tested
and the debug output of each test.
none No POST output is displayed.
Parameter Values Description
To Next Page
Loading...
