EasyManuals Logo

Oracle SPARC T7-2 User Manual

Oracle SPARC T7-2
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background image
Enable and Verify a DIMM
0:0:0>Master set ACK for vbsc runpost command and spin...
Note - The server might boot automatically at this point. If so, go to step f. If the server remains
at the OpenBoot prompt (ok) go to the next step.
e.
If the server remains at the OpenBoot prompt, type boot.
f.
Return the virtual keyswitch to Normal mode.
-> set /HOST keyswitch_state=Normal
Set 'keyswitch_state' to 'Normal'
g.
Switch to the system console and type:
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in “Identify
Faulted Components” on page 31.
4.
Switch to the Oracle ILOM command shell.
5.
Type:
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CMP0/CMP/MR0/BOB1/CH0/DIMM
/SP/faultmgmt/0 | timestamp | Nov 18 16:02:56
/SP/faultmgmt/0/ | sunw-msg-id | SPSUN4V-8000-CQ
faults/0 | |
/SP/faultmgmt/0/ | uuid | 7c7efb20-3333-e2d7-b8ea-986b3e9dbaa9
faults/0 | |
/SP/faultmgmt/0/ | timestamp | Nov 18 16:02:56
faults/0 | |
If the show faulty command reports a fault with a UUID go to the next step. If show faulty
does not report a fault with a UUID, you are done with the verification process.
6.
Switch to the system console and type the fmadm repair command with the UUID.
Use the same UUID that was displayed from the output of the Oracle ILOM show faulty
command.
110 SPARC T7-2 Server Service Manual • July 2019

Table of Contents

Other manuals for Oracle SPARC T7-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oracle SPARC T7-2 and is the answer not in the manual?

Oracle SPARC T7-2 Specifications

General IconGeneral
BrandOracle
ModelSPARC T7-2
CategoryServer
LanguageEnglish

Related product manuals