Oracle SPARC T7-2 - Page 43

Configure POST
See “Log In to Oracle ILOM (Service)” on page 30.
2.
Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
This example sets the virtual keyswitch default_level to min, which configures POST to run
according to other parameter values.
-> set /HOST default_level=min
Set default_level to min
For possible values for the default_level parameter, type:
-> help /HOST diag
/HOST/diag : Manage Host Power On Self Test Diagnostics
Targets:
Properties:
default_level : Diag level in the default cause (no error or hw change)
default_level : Possible values = off, min, max
default_level : User role required for set = r
default_verbosity : Diag verbosity in the default cause (no error or hw
change)
default_verbosity : Possible values = none, min, normal, max
default_verbosity : User role required for set = r
error_level : Diag level when running after an error reset
error_level : Possible values = off, min, max
error_level : User role required for set = r
error_verbosity : Diag verbosity when running after an error reset
error_verbosity : Possible values = none, min, normal, max
error_verbosity : User role required for set = r
hw_change_level : Diag level when running after a hw change
hw_change_level : Possible values = off, min, max
hw_change_level : User role required for set = r
hw_change_verbosity : Diag verbosity when running after a hw change
hw_change_verbosity : Possible values = none, min, normal, max
hw_change_verbosity : User role required for set = r
->
Detecting and Managing Faults 43