Performing Initial Configuration (CLI)
enable => Enable the ntp service
disable => Disable the ntp service
get [prop] => Get value for property [prop]. ("help properties"
for valid properties.) If [prop] is not specified,
returns values for all properties.
set [prop] => Set property [prop] to [value]. ("help properties"
for valid properties.) For properties taking list
values, [value] should be a comma-separated list of
values.
hostname:maintenance system setup ntp> set servers=0.pool.ntp.org
servers = 0.pool.ntp.org (uncommitted)
hostname:maintenance system setup ntp> commit
hostname:maintenance system setup ntp> done
aksh: done with "ntp", advancing configuration to "directory" ...
5.
Configure name services.
For detailed information, see “Configuring Services” in Oracle ZFS Storage Appliance
Administration Guide, Release OS8.8.x.
Note - Active Directory has two modes: domain and workgroup mode, which dictate how
SMB users are authenticated. In domain mode, SMB clients are authenticated through the
Active Directory domain controller, and you must ensure that the times on the appliance and the
domain controller match within five minutes.
NIS is an older directory protocol that is not very secure, and largely replaced by LDAP. It is
not recommended to run NIS and LDAP at the same time because they use the same domain
name setting.
Configure Name Services. Configure directory services for users and groups. You
can configure and enable each directory service independently, and you can
configure more than one directory service.
Subcommands that are valid in this context:
nis => Configure NIS
ldap => Configure LDAP
ad => Configure Active Directory
help [topic] => Get context-sensitive help. If [topic] is specified,
Configuring the Appliance for the First Time 261
To Next Page
Loading...
Need help?
General
