Oracle ZFS User Manual

Installing a ZS9-2 onto the Rack Slide Rails
insert the mounting screws through the front and rear slide-rail brackets and
rack posts.
4.
Repeat Steps 1 through 3 for the other slide-rail assembly.
Installing a ZS9-2 onto the Rack Slide Rails
Use the following procedure to install a ZS9-2 controller onto the rack slide rails.
Caution - This procedure requires a minimum of two people, or a mechanical lift, because of
the weight of the chassis. Attempting this procedure alone could result in equipment damage or
personal injury. Always load the heaviest equipment (disk shelves) at the bottom of the rack.
1.
If your rack includes an anti-tip foot, extend it from the bottom of the rack.
2.
Lower the rack stabilization feet if you have not already done so.
3.
Push the slide rails into the slide-rail assemblies in the rack as far as possible.
118 Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x • August 2021

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)