Oracle ZFS User Manual

Installing a ZS9-2 onto the Rack Slide Rails
4.
Raise the chassis so that the back ends of the mounting brackets are aligned
with the slide rail (1) and insert the chassis into the slide rails, pushing
the chassis slowly, until the mounting brackets meet the slide-rail stops
(approximately 12 inches, or 30 cm).
Caution - When inserting the controller into the slide rail, ensure that both the top and bottom
mounting lips of the mounting brackets are inserted into the slide rail. The controller should
slide forward and backward easily if correctly installed. If the unit does not slide easily, ensure
that each mounting lip is inserted properly. If the mounting brackets are not inserted properly,
the unit may fall when removing it from the rack, causing equipment damage and possibly
personal injury.
5.
Simultaneously push and hold the green slide-rail release buttons on each
mounting bracket (2) while you push the chassis into the rack. Continue pushing
Installing a ZS9-2 Controller 119

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)