Oracle ZFS User Manual

Installing a ZS5-2 onto the Rack Slide Rails
Installing a ZS5-2 onto the Rack Slide Rails
Use the following procedure to install a ZS5-2 controller onto the rack slide rails.
Caution - This procedure requires a minimum of two people because of the weight of the
chassis. Attempting this procedure alone could result in equipment damage or personal injury.
Always load equipment into rack from the bottom up.
1.
If your rack includes an anti-tip foot, extend it from the bottom of the rack.
2.
Lower the rack stabilization feet if you have not already done so.
3.
Pull the slide rails (mounted in the slide-rail assembly) toward you until the slide
rails stop (approximately 12 inches (30 cm) out of the rack).
4.
Raise the chassis so that the back ends of the mounting brackets are aligned
with the slide rail and insert the chassis into the slide rails, pushing the chassis
slowly, until the mounting brackets meet the slide rail stops (approximately 12
inches (30 cm) out of the rack). You will hear an audible click.
Installing a ZS5-2 Controller 163

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)