Oracle ZFS User Manual

Installing the Mounting Brackets on a 7x20
Installing the Mounting Brackets on a 7x20
Use the following procedure to install the mounting brackets on a 7420, 7320, or 7120
controller.
Note - If the mounting brackets are shipped inside the slide rails, you must remove them before
beginning this procedure; see “Removing the 7x20 Mounting Brackets from inside the Slide
Rails” on page 203.
1.
Position a mounting bracket against the chassis so that the slide rail lock is at
the front of the chassis, and the keyhole openings on the mounting bracket are
aligned with the locating pins on the side of the chassis.
Installing a 7x20 Controller 205

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)