Oracle ZFS User Manual

Verifying Operation of ZS5-2 Slide-Rails and CMA
Note - If you need to install additional Velcro straps, wrap the straps around the cables only, not
around any of the CMA components; otherwise, expansion and contraction of the CMA slide
bars might be hindered when the server is extended from the rack and returned to the rack.
Verifying Operation of ZS5-2 Slide-Rails and CMA
Use the following procedure to verify the operation of the CMA and slide rails for a ZS5-2
controller.
Before You Begin
Ensure all rack anti-tilt devices are extended to prevent the rack from tipping forward when the
storage controller is extended from the rack.
1.
Slowly pull the storage controller out of the rack until the slide-rails reach their
stops.
2.
Inspect the attached cables for any binding or kinks.
3.
Verify that the CMA extends fully with the slide-rails.
4.
Push the storage controller back into the rack and verify that the CMA retracts
without binding.
5.
Adjust the cable straps and the CMA, as required.
174 Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x • August 2021

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)