Machine Manual Orion
AG 360 RoboWrapper Revision 1.1
Introduction and Safety 28 June 2017
Page 1-4
Operation Safety
The following safety precautions are recommended for all personnel who will operate this
AG 360 RoboWrapper.
• Operators should immediately report unsafe working conditions to a supervisor.
• The operator should understand the function of the entire system including all external
devices and equipment that interact with the system.
• Before starting operation, the operator should understand the complete task that the
system is designed to accomplish.
• The operator should know the location and functional status of all devices (switches,
sensors, control signals) that can cause the system to move.
• The operator should know where each EMERGENCY STOP button is located for
both main and external control devices. Do not hesitate to use them in an emergency.
• The operator should make sure all safety devices are functioning and periodically
checked for proper operation.
• The operator should ensure that all personnel are outside the system before starting
operation.
• The operator should never cross in front of the machine while in operation.
Maintenance Safety
The following safety precautions are recommended for all personnel who are responsible
for the maintenance or service this AG 360 RoboWrapper.
• Personnel should ensure that all safety devices are functioning and periodically
checked for proper operation before performing maintenance.
• Before performing any maintenance, service, or inspection inside the AG 360
RoboWrapper, the power source should be turned off and locked out.
• Maintenance should be performed on the system with the power OFF. Lockout and tag
out procedures should be followed to protect personnel from injury and to indicate the
equipment is being serviced.
• Personnel should pay careful attention to all devices that may be powered or capable
of motion, such as conveyors and pneumatic devices.
• Use only specified replacement parts. Never use non-specific fuses that have not been
specified. Potential fire and/or damage may result.
• Before restarting the system, ensure personnel are not in path of the system and that
the system and external devices are operating properly.
To Next Page
Loading...
Need help?
General
