Orion Machine Manual
Revision 1.1 AG 360 RoboWrapper
28 June 2017 Introduction and Safety
Page 1-13
Operating Parameters
To ensure safe and reliable operation, please check the below conditions before installing
the machine:
• Power source available for charging
• Battery charge power is 110v/220v (+- 10%)
• Battery charge power Hertz is 50/60 Hz. (+- 2%)
• Machine is workable under the temperature between 32 - 104
• This machine should only operate on flat hard surfaces, not intended for outdoor use
Checks Prior to Running
For the safety of the operator, please ensure the following conditions are met:
• Ensure the battery is charged prior to operation.
• Make sure there are no objects on top of the carriage.
• Avoid any damp objects or water around the electrical components.
• Ensure there is no film remnants in the way of the machine path.
• Do not stand on or across the machine during operation.
• When a problem occurs, please check the troubleshooting chart in chapter 4 of this
manual.
• Ensure there is a clear path of 52” around all sides of the load prior to wrapping.
Figure 1 - 10
AG 360 Path of 52”
To Next Page
Loading...
Need help?
General
