Orion Machine Manual
Revision 1.1 AG 360 RoboWrapper
28 June 2017 System Operation
Page 3-17
BOTTOM WRAPS
Press this button to set the number of bottom wraps applied to the load. Parameters
are 1-20.
UP SPEED
Press this button to change the speed of the carriage on the upward move, in terms
of percentage. Min - 5% Max - 100%
DOWN SPEED
Press this button to change the speed of the carriage on the downward move, in
terms of percentage. Min - 5% Max - 100%
WRAPPING SPEED
Press this button to adjust the wrapping speed while in automatic operation, in terms
of percentage. Min - 5% Max - 100%
UP AND DOWN TIMES
Press this button to set the number of times the carriage travels up and down during
the cycle.
FILM TENSION Press this button to set the film tension percentage.
INSTA CUT DELAY
Press this button to set the delay timer for the insta-cut. This allows the user to delay
the timing of the instacut by increasing the timer.
STANDARD WRAP
Press this button to select the Standard wrap sequence. When selected, the wrapper
will apply the bottom wraps first. When complete, the Carriage will travel to the top
of the load and apply the top wraps. When complete, the Carriage will travel to the
bottom and complete the cycle.
WRAP UP ONLY
Press this button to wrap up only. The machine will wrap to the top, then stop the
cycle.
WAIT ON TOP
Press this button to wrap up only. The machine will wrap to the top, then stop the
cycle.
Table 3-5. The Wrap Settings Screen Button Descriptions (Continued)
STATE 1 DESCRIPTION
To Next Page
Loading...
Need help?
General
