Orion FLEX Series - Page 71

Orion Machine Manual
Revision 1.1 AG 360 RoboWrapper
28 June 2017 Troubleshooting
Page 4-7
E-8 HEIGHT PHOTOCELL NOT FIND
OBJECT
• Photocell not find object at start
• Photocell broken or circuit fault
E-9 LIFT UNIT NOT IN HOME POSI • Lift unit not in home position
• Lift unit low journey fault or cir-
cuit fault
E-13 BRAKE OPEN • Brake open
• Manual brake mechanism open
• Brake protection proximity fault
or circuit fault
Table 4-1. Alarm Message Chart (Continued)
ALARM NO FAULT SOLUTION