Panasonic 2WAY Multi - Page 149

V–30
4) Outdoor Unit Setting List (1)
Data code Data Data code Data
←Down Up→
00 70
~71
3F 72
40 73
41 74
42 Minimum set revolution speed 75
43 Maximum set revolution speed 76
44 Oil change time display switch 77 Mixer offset
78
79
7A
7B
45 7C
46 Automatic cooling/heating mode 7D
47 7E
48 7F Engine linked operation time setting
49 80
4A 81
4B 82
4C 83 Reference system
4D 84 Cooler/heater auto-control
4E 85 Revolution speed differential reference
4F 86
50 α1 (Cooling high-pressure offset) 87
51 α2 (Heating high-pressure offset) 88 Ignition time offset
52 α3 (Cooling low-pressure offset) 89
53 α4 (Heating low-pressure offset) 8A
54 α5 (Cooling low-pressure offset 2) 8B
55 α6 (Heating low-pressure offset 2) 8C
56 Fuel adjustment valve offset 8D
57 Silent 8E
8F
90
91
92
93
58 Silent start 94
59 Silent end 95
5A 96
5B Anti-freezing temperature 97 Indoor unit solenoid valve open/close
5C Throttle offset 98 Indoor unit drain pump on/off
5D
Outdoor unit solenoid valve heater
thermostat on initial opening
99 Catalyst temperature sensor existence
5E 9A
5F 9B
60 Thermostat off diff 9C
61 Thermostat on diff 9D
62 Cooling/heating switch diff 9E
63 GUF thermostat off diff 9F
64 GUF thermostat on diff
65 GUF cooling/heating switch diff
66
Outdoor unit solenoid valve heater
operation lowest opening
67
68
69
6A
6B
6C
6D
6E
6F Anti-freezing timer
(The default value is the reference value. Subject to amendment without prior notice.)
GHPtroubleshooting.indbV‒30GHPtroubleshooting.indbV‒30 2012/11/2611:20:202012/11/2611:20:20