110
Fingerprint Reader
You can increase your computer’s security level by setting the BIOS level described in this section.
There is [Fingerprint Security] in [Security] menu in the Setup Utility. Can be changed only when [Set Supervisor Password] is
set.
More Advanced Security
Sub-Menu Protection
You can change displayed or not displayed and enabled or disabled of the Sub-Menu.
Not Protected
Protected
Power-on Security
Change Enable or Disable of Power-on Security ( page 109).
When the Power-on Security is set to [Disabled], the Power-on Security does not function even if
[Power-on Security] is set to [Enabled] on the Setup Utility.
Disabled
Enabled
Security mode
You can start up Windows by sliding a registered finger when [Simple] is set.
If you set [High], you have to enter Supervisor Password by following authentication in Power-on
Security.
It will not be displayed if Power-on Security is disabled.
Simple
High
To Next Page
Loading...
