Panasonic CF-C1 Series User Manual

163
Troubleshooting (Advanced)
Click [Start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B Double-click [PCMCIA adapters], and double-click the relevant device.
In [Resources], if [Conflicting device list] shows [No conflicts], there is no conflict.
 Read the instructions supplied with the PC Card, or consult the PC Card manufacturer.
 Check that you are using a driver supported by the operating system.
You do not know the available RAM module
 Refer to “Expanding Memory” ( page 92).
Microsoft Windows Logo Authentication is not obtained
 If “This driver is not digitally signed!” message is displayed, the driver you attempt to install may not have obtained
Microsoft Windows Logo Authentication. Consult the peripheral manufacturer.
To check if the additional RAM module has been installed successfully
 If the installation is successful, the main memory and total RAM module size appears in the [Information] menu of the
Setup Utility ( page 136).
 If the RAM module is not confirmed:
• Turn the computer off and reinsert the RAM module.
• Confirm the recommended specifications.
Regarding the RAM module, refer to “Expanding Memory” ( page 92).
The address map for IRQ, I/O port address, etc. is unclear
 You can check with the following procedure.
A
Click (Start) - [Computer] - [System properties] - [Device Manager].
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B Click [View] - [Resources by type].
Windows XP
Windows 7
Windows XP

Panasonic CF-C1 Series Specifications

General

Operating System	Windows 7 Professional
Processor	Intel Core i5
Storage	SSD
Display	12.1-inch
Graphics	Intel HD Graphics
Weight	Approx. 1.5 kg
Battery	Lithium Ion
Wireless	Wi-Fi, Bluetooth
Ports	USB, HDMI, VGA, Ethernet, SD card slot