124
Disabling/Enabling Wireless Communication
To check the wireless communication status
1
Click on the notification area and place the cursor over the Wireless Switch Utility icon.
Place the cursor over the Wireless Switch Utility icon on the notification area.
NOTE
Do not turn on/off the switch repeatedly at too short intervals.
Do not restart, log off, or enter sleep or hibernation immediately after turning on/off the switch.
Do not turn on/off the switch while Windows is starting up.
To use wireless communication, set the wireless devices ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enabled]
(default) in the [Advanced] menu of the Setup Utility.
It may take some time to turn off wireless communication after switching the wireless switch off.
If the IEEE802.11a setting is changed in [Device Manager], the display will be changed accordingly.
You can automatically disable the wireless LAN connection when a LAN cable is connected to your computer. You need to
install the Wireless Connection Disable Utility to use this function.
Installing the utility
1 Log on to Windows as an administrator.
2 Click [start] - [Run] and input [c:\util\wdisable\setup.exe], and click [OK].
3 Follow the on-screen instructions to install the Wireless Connection Disable Utility.
Wireless Connection Disable Utility
Windows 7
Windows XP
Windows XP
To Next Page
Loading...
