Panasonic CF-C1 Series

64
Sleep/Standby or Hibernation Functions
 To resume from sleep/standby or hibernation
1 Open the display, or slide the power switch (A).
 In the default setting, the Windows password will be requested to resume.
CAUTION
 Do not perform the following operations until resuming is complete. After the display is resumed, wait approximately
15 seconds (normally) or 60 seconds (when the computer is on a network).
• Touch the keyboard (except for password input), Touch Pad, screen, or power switch.
• Use an external mouse or other peripheral devices.
• Connect or disconnect the AC adaptor.
• Close or open the display.
• Shut down or restart Windows.
• Enter sleep / standby or hibernation (Wait approximately one minute).
• <Only for CF-F9 Series>
Operate the drive power/open switch.
• Operate the wireless switch.
• Insert and remove the SD/SDHC Memory Card
*2
.
 If the computer enters sleep while a USB keyboard or mouse is connected, touching the USB keyboard
keys or mouse will resume the computer.
NOTE
 <Only for model with Bluetooth>
After resuming from
sleep / standby or hibernation, the message “TosBtMng has stopped
working” may appear.
Click [Close program].
If Bluetooth connections are cut off, click (Start)/ [start] - [All Programs] - [Bluetooth] -
[Bluetooth Settings], and connect to the Bluetooth devices again.
*1
If the speakers are muted, beeps do not sound.
*2
SD/SDHC/SDXC Memory Card.
<CF-C1 Series> <CF-F9 Series>
A
Windows 7
Windows XP
Windows 7
Windows 7
Windows XP
Windows 7
Windows XP
Windows 7