182
Intel
®
Active Management Technology
<Only for model with Intel
®
AMT>
Intel
®
AMT offers the operational management function and security function through network.
1 Turn on the computer, and press
F2
or
Del
while [Panasonic] boot screen is displayed.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
2 If the Supervisor Password is not set, select the [Security] menu, then set Supervisor
Password.
3 Select the [Security] menu, and select [AMT Configuration], and press
Enter
.
4 Select [Intel(R) AMT] and press
Enter
.
5 Select [Enabled] and press
Enter
.
6 Select [Intel(R) ME Setup Prompt] and press
Enter
.
7 Select [Enabled] and press
Enter
.
8 Press
Esc
.
If you do not use the Supervisor Password, clear the Supervisor Password following steps.
A Select [Set Supervisor Password], and press
Enter
.
B Enter the Current Password, and press
Enter
.
C Press
Enter
when the [Create New Password] display is shown.
D Press
Enter
when the [Confirm New Password] display is shown.
9 Press
F10
.
At the confirmation message, select [Yes] and press
Enter
.
The computer will restart.
The following procedures are example. It is different according to your environment. Contact your technical support
office.
A Press
Ctrl
+
P
when [Press <CTRL - P> to enter Intel(R) ME Setup] is shown after the [Panasonic] boot screen
disappears.
B Press
1
.
C Enter “admin” in [Intel(R) ME Password], and press
Enter
.
D Enter the New Password in [Intel(R) ME New Password] to change the password, and press
Enter
.
At confirmation message, enter the password, and press
Enter
.
Write down new password to remember you password. The password has the limitation ( page 184).
Setting AMT configuration
To Next Page
Loading...
