Panasonic CF-C1 Series

48
Battery Power
Be careful about the battery pack direction.
In case that the projection does not match the dents of the computer, detach the battery pack once, then slide it
while pushing it lightly to avoid floating.
CAUTION
 Make sure the latches are securely locked, otherwise the battery pack may fall when you carry the computer.
 Do not remove the battery pack forcibly when the latches are locked. Doing so may damage the battery pack.
 Do not apply pressure from the top of the closed display when the battery pack has been removed. Doing so may
damage the LCD.
<For CF-C1 Series operating on the battery packs 1 and 2>
If one of the two battery packs has remaining power, you can replace the other battery pack without turning off the computer
(Hot swap).
First check the battery with less remaining power, which is to be replaced ( page 41).
1 Turn your computer over and remove/insert the battery pack.
 To remove
Slide the latch corresponding to the battery pack to be replaced to the unlocked position, and pull out the battery
pack.
 To insert
Slide the battery pack into the battery compartment until it clicks to the secured position.
<CF-C1 Series> <CF-F9 Series>