4-88 System Programming
4.5.10 Voice Mail Integration
Parameter
Value Range
(default)
Description/Function Reference
Specifies the Leave Message command.
This command is transmitted to a VM port if a call is
forwarded or intercepted and rerouted to the VM port.
Specifies Get Message command.
This command is transmitted to a VM port when the
message receiver presses the MESSAGE button to
retrieve voice message.
Specifies AA (Automated Attendant) Service command.
If AA Service is set to “Start” by system programming,
this command is sent to a VM port if an incoming CO
call is answered by the VM port.
Specifies VM (Voice Mail) Service command.
This command is transmitted preceding the “Get
Message” command above. This is effective to switch
to a VM port when an AA port lights the MESSAGE
indicator.
This command is also transmitted preceding the “Leave
Message” command if Operator transfers a call to an
extension and then it is forwarded to an AA port so that
the AA port can be switched to VM port temporarily.
(H)
(H)
(#8)
(#6)
Leave Message
Get Message
AA Service
VM Service
Voice Mail Commands
The following parameters (up to 16 digits for each) can be programmed using “ 0 through 9,” “. ,” “#” and “H.”
To Next Page
Loading...
