Panasonic KX-TD500 - Page 256

System Programming 4-117
4.10.4 System Parameters4.10.4 System Parameters
Parameter
Value Range
(default)
Description/Function Reference
A stop bit code indicates the end of a bit string which
composes a character. Select an appropriate value
depending on the requirements of your printer or
personal computer.
[Note]
• Port 1 is fixed to “1.”
A parity code indicates what type of parity is used to
detect an error in the string of bits composing a
character. Make an appropriate selection depending on
the requirements of your printer or personal computer.
Specifies the NL Code for your printer or personal
computer. If your printer or personal computer
automatically feeds lines with a carriage return, select
“CR. (Carriage Return)”
If not, select “CR+LF (Line Feed).”
Specifies the data transmission speed from the system
to the printer or personal computer.
Defines the number of bits in each byte or character.
A stop bit code indicates the end of a bit string which
composes a character. Select an appropriate value
depending on the requirements of your printer or
personal computer.
1. 1 bit
2. 2 bits
(1)
1. None
2. Mark
3. Space
4. Even
5. Odd
(None)
1. CR+LF
2.
CR
(CR + LF)
1. 2,400 b.p.s
2. 4,800 b.p.s
3. 9,600 b.p.s
4. 19,200 b.p.s
(9,600)
1. 7 bits
2. 8 bits
(8)
1. 1 bit
2. 2 bits
(1)
Stop Bit:
SMDR (Port 2)
Parity
NL (New Line)
Code
Baud Rate
(Modem Speed)
Word Length
Stop Bit: