Panasonic KX-TD816 - Page 247

4.1.3 Entering Characters
Please see the following example which shows how to select a
desired character.
For example, to select the letter “M”:
Select either of the following two methods:
(1) Using the SHIFT and Soft buttons (for display DPT only)
* See Combination Table 1.
1. Press 6. (“M” belongs to “6.“)
l The Function Line shows: M N 0
2. Press the Soft 1 (M) button.
(Press SHIFT to display the lower case of the above letters.)
(2) Using the SELECT button
* See Combination Table 2.
1. Press 6. (“M” belongs to “6.“)
2. Press the SELECT button once.
l Pressing the SELECT button an appropriate number of
times gives you the desired letter. Pressing SELECT
twice gives the letter “m,” pressing three times gives “N,”
and so on.
Example of entering characters: to enter “Mike”:
Using method (1)
* See Combination Table 1.
The display shows:
1. Enter 6.
2.
Press Soft 1 (M).
3. Enter 4.
4. Press SHIFT.
5. Press Soft 3 (i).
6.
Enter 5.
7.
8.
Press Soft 2 (k).
Enter 3.
4-10
System Programming