Panasonic KX-TD816 - VM Status DTMF Set

113
43
0 System Programming
VM Status DTMF Set
Description
Sets the DTMF signals transmitted to your Voice Processing
System (VPS) to inform the VPS of the VPS ports states quickly:
The following signals are sent to the VPS with the assigned DTMF
signals:
RBT (ringback tone) : This signal is sent when calling an
extension.
BT (busy tone)
: This is sent when the called extension is
busy.
ROT (reorder tone)
: This is sent when the dialed number is
invalid.
DND (DND tone)
: This is sent when the other extension has
DND assigned.
Answer
: This is sent when the other extension
answers the call.
Disconnect
: This is sent when the other extension
hangs up.
Confirm (confirmation tone) :
This is sent when the feature number for
“Message Waiting Lamp” is valid.
FWD VM RBT (FWD to VM ringback tone) :
‘Not available (reserved).
FWD VM Bk (FWD to VM busy tone) :
This is sent when the called extension
has set Call Forwarding to VPS.
FWD EXT RBT (FWD to extension ringback tone) :
Not available (reserved).
Selection
l RBT / BT / ROT / DND / Answer / Disconnect / Confirm /
FWDVMRBT/FWDVMBT/FWDEXTRBT
l DTMF signal number: 3 digits (max.)
Default
RBT - 1; BT - 2; ROT - 3; DND - 4; Answer - 5; Disconnect - #9
Confrrm-9;FWDVMRBT-6;FWDVMBT-7;FWDEXT
RBT-8
Programming 1. Enter 113.
Display: VM Status Set
2.
Press NEXT to program ringback tone status.
To program another status, keep pressing NEXT until the desired
status is displayed.
Display example: RBT
:1;
4-44
System Programming