Panasonic KX-TD816 - VM Command DTMF Set

114
43 0
System Programming
VM Command DTMF Set
Description
Sets the DTMF command signals transmitted to your Voice
Processing System (VPS). There are four commands available:
Leave Message; Get Message; Automated Attendant Service; Voice
Mail Service. These commands are used in the following ways:
(A) If your VPS is used for Voice Mail (VM) Service
(1) Call Forwarding: / Interceot Routing to Voice Mail
If a call is forwarded to the VPS, your system will send a mailbox
number to the VM port. This allows the caller to leave a message
without knowing the mailbox number.
l Required entries (selections):
LV-MSG (Leave Message): This command is transmitted to a
VM port if a call is forwarded or intercepted and rerouted to the
port.
AA-SVC (Automated Attendant Service): If AA Service is set to
“Start” in program [990], field (lo), the “AA-SW” command is
sent to a VM port if an incoming CO call is answered by the VM
port.
l Other programming required (program addresses): [ 1061; [602];
[609]; [990], field (10); [990], field (18)
(2) Hearing the message at the extension
If the VPS receives a message and lights the MESSAGE button
indicator of the concerned telephone, the telephone user can hear
the message by pressing the MESSAGE button.
:
--?
I
l Required entries (selections):
GETMSG (Get Message): This command is transmitted to a VM
port when the message receiver presses the MESSAGE button.
VM-SVC (Voice Mail Service): The “VM-SVC” command is a
code transmitted preceding the “GETMSG” command above.
This is effective to switch to VM port when an AA port lights the
MESSAGE indicator.
l Other programming required (program addresses): [609]; [990],
field (18)
(B) If your VPS is used for Automated Attendant (AA) Service
An AA port answers an incoming CO call to provide AA services,
such as call transfer, receiving a message.
l Required entries (selections):
VM-SVC (Voice Mail Service): The “VM-SVC” command is a
code transmitted before “LV-MSG” code if Operator transfers a
call to an extension and then it is forwarded to an AA port so that
the AA port can be switched to VM port temporarily.
l Other programming required (program addresses): [ 1061, [602]
4-46
System Programming