The following programming instructions suppose that you have
already entered programming mode and that you will employ
method (2) on page 4-8.
Example: Program [OOl] “System Speed Dialing Number Set”
4.1.4
Example of Programming
Sample of Description
I
I
I
Explanation
001'1)
4.2 Manager Programmingz)
i
(1)
Program address: This address is printed at the top
I
I
I
of every page to allow you to quickly find the
System Speed Dialing Number Set3’
I
I
desired program.
-
I
Description “’
Used to pro,- the System Speed
)
(2) Running title: tells you which group the program
I
Dial numbers. These numbers are
I
belongs to.
available to all extension users. There i (3) PrOgratII title.
are 100 numbers from 00
through 99.
1
(4) Provides a more detailed description of the
I
program.
Selection ‘5’
l
Speed dial number: 00
through 99
[
(5)
Shows you choices that you can assign.
l
Telephone number: 24 digits
(max.)
1
(6)
Shows you the default (factory setting).
Default@
All speed
dial numbers -
Not stored
i
(7) Shows you programming procedures step by step.
Programming””
1.
Enter
OOl.‘*’
I
4
l
While programming, use the overlay.
Display: SPD Number Set"'
i
l
Before starting to program, enter the
I
2. Press
NEXT.“”
I
programming mode. (See “Entering the
I
Display:
SPD Code?->“”
3. Enter a
speed dial number.
programming mode” on page 4-6.)
1 (8)
Enter the program address.
I
(9) The
display shows the program title. If your
I
To enter
speed dial number 00,
I
I
telephone has soft buttons, the lower line shows
you
can also press NEXT.
I
I
the functions that are currently assigned to them.
I
Display example: 0O:Not
; (10) Press either
Soft 3
(NEXT
)
shown on the display
I
Stored!1r’
I
or the
NEXT
shown on the overlay.
4. Enter a
telephone number. ‘13)
1
I
(11) The message line advises you to enter a speed dial
number.
To delete me current entry, press
i
CLEAR. I“’
; (12) If the telephone number has already been stored,
1
To change the current entry, press
’
the number is displayed.
CLEAR
and the new number.
i
(13) Enter the telephone number that you want to store.
I
5. Press
STORE.“”
I
Your entry is displayed as you enter the digits.
f
(14) Pressing
CLEAR erases &e
whole entry.
6. To Program ano*er speed dial
number, press
NEXT
or
j ( 15) your entry is now store-J_
I
I
PREV,
or
SELECT
and the
i
The indicator lights red and confirmation tone lets
desired speed dial number.“@
you know that the storage is completed.
7. Repeat steps 4 through 6. ‘17)
I
;
(16)
Select the best way for you to store another speed
8. Press
END. “*’
I
dial number. Pressing the
NEXT / PREV
allows
8
0
/
you
to
select the next higher / lower speed dial
I
1
number. You can also keep pressing them until the
I
I
desired one is displayed. If you press
SELECT
I
I
4-12
System Programming
To Next Page
Loading...
