Panasonic KX-TD816 - Caller ID Code Set

110
43
a
System Programming
Caller ID Code Set
Description
Sets the identification code of the calling party (Caller ID Code) to
utilize Caller ID Service provided by a specific central office (CO).
If an ID Code transmitted from CO is found in Caller ID Code
Table, the caller’s ID Code or a name given to the code in program
[ 11 l] “Caller ID Name Set” is displayed on the telephone, allowing
the called party to recognize the caller.
-\
Selection
Default
Programming
Conditions
l Location number: 001 through 250
9 Caller ID Code:
11 digits (max.)
All locat’ions - Not stored
1.
Enter 110.
Display :
Caller ID Code
2.
Press NEXT.
Display :
Location NO?->
3.
Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: OO1:Not Stored
4.
Enter a Caller ID Code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new code.
5.
Press STORE.
6. To program another location, press NEXT or PREV, or
SELECT and the desired location number.
,e
7.
Repeat steps 4 through 6. Y_
8.
Press END.
l There is a maximum of 250 Caller ID Codes. Each code has a
maximum of 11 digits, consisting of 0 through 9.
._
l Program [ 11 l] “Caller ID Name Set” is used to give names to Caller ID
Codes. If an ID Code is given a name, the called party’s telephone
shows the name in place of the ID Code.
. Program [406] “Caller ID Assignment” is used to enable Caller ID
Service on a CO line basis.
Feature References
Section 3, Features,
Caller ID
4-42
System Programming