Panasonic KX-TD816 - Call Transfer to CO Line

503
47 0 COS Programming
Call Transfer to CO Line
Description
This program determines which Classes of Services (COS) are
allowed to perform the Call Transfer to CO Line function.
Selection
l COS number: 1 through 8, * ( * =a11 COS)
l Enable / Disable
Default
All COS - Enable
Programming
1.
Enter 503.
Display: Transfer to CO
Conditions
2.
Press NEXT.
Display : COS NO?->
3.
Enter a COS number.
To enter COS number 1, you can also press NEXT.
Display example: COSl:Enable
4.
Keep pressing SELECT until the desired selection is
displayed.
5.
Press STORE.
6.
To program another COS, press NEXT or PREV, or
SELECT and the desired COS number.
7.
Repeat steps 4 through 6.
8.. Press END.
l To assign all COS to one selection, press the * key at step 3. In this
case, the display shows the contents programmed for COS 1.
l Program [601] “Class of Service” is used to assign a Class of Service to
each extension.
Feature References
Section 3, Features,
Call Transfer, Screened - to CO Line
4-98
System Programming